Orca Slicer and BambuLab P1S will not flush filament when using print

Prime Tower Orca Slicer. Orca Slicer Tutorial Part 1 What to do with brand new filament YouTube When i use prime tower and switch filaments and it goes to start printing and goes over to the prime tower Just set up an M600 macro that will pause the print, park the toolhead, then retract the filament out of the nozzle so you can change it

Prime volume: We cannot set the prime volume for time-lapse prime tower, it is only composed of two outer walls, the middle is hollow, and the depth is fixed The Prepare tab does not take in to account the brim width of the Prime tower, but this doesn't should block the movement of the Prime tower.

Disabling prime tower when printing with multiple filaments sometimes

Prime volume: We cannot set the prime volume for time-lapse prime tower, it is only composed of two outer walls, the middle is hollow, and the depth is fixed Yes you can use the prime tower only but you do have to add 2 or more filaments so the prime tower will show up on the bed and yes you can move the prime tower to your seam location Learn how Orca Slicer works in this guide, from installation to customizing the settings and mastering the advanced features.

OrcaSlicer An Introduction and How to Get Started Obico Knowledge Base. Every object on the bed plate should move freely inside the print area defined The Prepare tab does not take in to account the brim width of the Prime tower, but this doesn't should block the movement of the Prime tower.

Orca Slicer and BambuLab P1S will not flush filament when using print. Orca bot: this issue is stale because it has been open for 90. Tried flush mm3 from 0-100 in flush volume calc, filament minimum purge in filament settings, and prime volume under prime tower settings with the only change is adding to the oversize first filament prime